Not Just a GM Thing

Keeping your EDR analysis skills sharp is critical in modern recon. This week’s installment should help, as we look at a commonly-held belief that turns out to be wrong.

The belief: pre-crash data only includes data sampled before the event. Some 1999-2009 GM vehicles were known to buck this axiom, but two of the greats, Wade Bartlett and Greg Russell, recently published an article in ARJ (May/June 2026) presenting several datasets where post-impact data was clearly categorized as pre-crash. Three of the cases were outside the known GM range (2014 Lexus, 2013 Ford, and 2013 Volvo).

Let’s go through one. The table below shows pre-crash data for a 2013 Volvo S60 that was towed into a stationary semi-trailer at ~25 mph, according to on-board instrumentation (thanks to FTG and NAPARS for running this test). However, the last speed sample, which is reportedly pre-crash, is 14.9 mph. Considering the test setup, that 14.9 mph was clearly measured post-impact (~75 ms according to the instrumentation).

Figure 6 from Wade and Greg's ARJ paper.

As the authors put it: “Because there is always a short period of time between first contact and Algorithm Enable, crash-affected data can be recorded in the Pre-Crash table for any manufacturer using a reactive system to initiate AE, and which identifies values recorded before AE as Pre-Crash.”

So be on the lookout for post-impact data making its way into your pre-crash data, and if you encounter such tomfoolery, it’s worth throwing this paper in your file for support!

Thanks for reading, keep exploring, and Happy Thanksgiving!

Lou Peck

Next
Next

Trick for Spotting Subtle Damage